PROCESSOR & STORAGE
- Powerful 720Mhz ARM8 processor with 128MByte DDR2 RAM
- 256MByte Flash memory storage (~120MB available on board space for user storage)
- microSD card slot for expandable storage
OPERATING SYSTEM
- Embedded Linux & Software Development Kit (SDK)
PEAK DATA SPEED
- Multi-band FDD capable LTE data rates:
Category 3
- Downlink:100 Mbps (20 MHz bandwidth)
50 Mbps (10 MHz bandwidth)
- Uplink:50 Mbps (20 MHz bandwidth)
25 Mbps (10 MHz bandwidth) CDMA EVDO Release 0 and EVDO Release A
- Downlink: Up to 42 Mbps (category 24)
- Uplink: Up to 5.76 Mbps (category 6) GSM/GPRS/EDGE
- EDGE throughput up to 236 kbps
CDMA IS-856 (1xEV-DO Release A)
- Up to 3.1 Mbps forward channel
- Up to 1.8 Mbps reverse channel CDMA IS-2000
- Up to 153 kbps, simultaneous forward and reverse channel
Circuit-switched data bearers up to 14.4 kbps UMTS (WCDMA)/HSDPA/HSUPA/HSPA+/DC-HSPA+
HSPA+ rates
- Downlink: Up to 42 Mbps (category 24)
- Uplink: Up to 5.76 Mbps (category 6) GSM/GPRS/EDGE
- EDGE throughput up to 236 kbps
CELLULAR BANDS LTE:
- Band 2 (1900 MHz)
- Band 4 (AWS) (1700 / 2100 MHz)
- Band 5 (850 MHz)
- Band 13 (700 MHz)
- Band 17 (700 MHz)
- Band 25 (1900 MHz G Block)
CDMA (EVDO Release 0 and EVDO Release A):
- BC0 (Cellular 800 MHz)
- BC1 (PCS 1900 MHz)
- BC10 (Secondary 800 MHz)
UMTS/HSDPA/HSUPA/HSPA+/DC-HSPA+:
- Band 1 (2100 MHz)
- Band 2 (1900 MHz)
- Band 4 (AWS 1700/2100 MHz)
- Band 5 (850 MHz)
- Band 8 (900 MHz)
GSM/GPRS/EDGE:
- GSM 850 (850 MHz)
- EGSM 900 (900 MHz)
- DCS 1800 (1800 MHz)
- PCS 1900 (1900 MHz)
GNSS:
- GPS: 1575.42 MHz
- GLONASS: 1602 MHz
CONNECTIVITY
- 2 x 10/100/1000 Base-T Ethernet RJ45 ports with Auto MDIX
- Micro USB 2.0 OTG interface with 0.5A supply capability
- 1 x multipurpose I/O pin
SIM CARD READER
- Lockable Tray Reader with Push-Button-to-Release
* optional soldered-down SIM (ETSI MFF2 DFN-8 USIM)
- Supports Mini USIM/SIM Format (2FF)
RESET BUTTON
- Reset button (recessed, requiring pen/paperclip) with three functions:
Reboot, reboot into recovery mode, and reset unit to factory defaults
ANTENNA CONNECTORS
- 2x SMA connectors for 3G/4G (1x Main and 1x RX Diversity)
- 2x Reverse SMA connectors for Wireless LAN (MIMO)
- 1x SMA connector for GPS
LED INDICATORS
- Tri-colour (Red/Amber/Green) LEDs. Power, WLAN, Mobile Broadband, Service Type and Signal Strength indicators
- Easy and clear LED status display for connection status, connected network type, and connection errors
CELLULAR
- Profile managed packet data connections
- NAT Disable for framed route configuration
- Transparent bridge mode using PPPoE to allow the router to transparently forward Public WAN IP address to a downstream device
- SIM Security Management (PIN configuration, enable and disable)
- Automatic and manual cellular band selection
- Automatic and manual operator selection
GPS
- Embedded GPS receiver (1575.42Mhz)
- SMA Connector for external passive or active GPS Antenna
- Active antenna voltage: 3.05V
- Maximum current: 50mA
- Tracking sensitivity under open sky: -161dBm
- Acquisition sensitivity under open sky: -145dBm
- Cold start sensitivity: -145dBm
- Time to first fix (TTFF): Cold 32s, Warm 29s, Hot 1s
WIFI/WLAN
- High throughput and extended range 802.11n 2T2R WiFi with transmission speeds up to 300Mbps
|
|
NETWORK & ROUTING
- Static Routing, RIP (v1/v2), Port Forwarding and DMZ
- Dynamic DNS
- VRRP for redundant router failover
- DHCP Server, including :
- Address reservation by MAC address
- Custom DNS server definitions
- DHCP Relay
- DHCP list display in Web-UI
- Advanced DHCP Option configuration (Option 42 NTP, Option 66 TFTP, Option 150, Option 160)
- Data Stream Manager providing ability to create mappings between input and output ports (e.g. Serial Port, SMS, GPS, USB) and perform required translation or data processing by each virtual tunnel.
- Modbus Server TCP/IP Gateway and Client TCP/IP Agent with up to 247 slaves connected to the Serial TCP/IP Gateway.
- Modbus RTU/ASCII frames support.
VPN
- PPTP Client for VPN connectivity to remote PPTP VPN Server
- IPSec tunnel termination (for up to 5 tunnels)
- GRE Tunnelling
- OpenVPN (Client, Server and P2P)
ADMINISTRATION & CONFIGURATION
- Web-based User Interface (HTTP/HTTPS) for full device status and configuration
- Password protected configuration file backup and restore for quick device configuration and device cloning
- Telnet Command Line Interface for status monitoring, configuration and control
- SNMP v1/v2 including cellular specific MIB, config and firmware download
- TR-069 Client for remote device configuration, configuration backup and restore, and firmware upgrade
- SMS Client (Send/Receive) including inbox, outbox
- Ping monitor watchdog (Reset connection on repeated ping failure)
- Diagnostic Log Viewer (remote and local)
- System Status and Security Logs
- NTP Server Support for network time sync of device’s system clock
- Device User Guide stored on the device and accessible via the Web-based User Interface (HTTP/HTTPS)
- Advanced Diagnostics and Control via SMS
- Query status information – such as Signal Strength, WAN IP, Uptime, and many more
- Configure device remotely via SMS – such as APN, authentication settings, and many more
- Execute commands via SMS – such as reboot, reset to defaults, go offline, and many more
- Secure SMS management using sender whitelisting and password management
- SMS acknowledgement replies for queries and commands
FIRMWARE MANAGEMENT
- Firmware Upgrade locally via LAN or remotely Over-The-Air (HTTP/HTTPS, SNMP, TR-069)
- Multiple firmware image storage on device and dynamic install
- Triggered firmware upgrade via SMS (initiate download & install from HTTP/HTTPS)
SOFTWARE DEVELOPMENT KIT
- Develop and install custom software applications
- Open Linux standard development environment
- Develop applications/scripting in standard ANSI C/Shell script and LUA
- Package manager built into Web-UI for Application installation/removal
- API (C, LUA and Shell libraries) to the unit’s internal Runtime Database to allow full status monitoring configuration and control of the device from custom applications
TEMPERATURE
- Operating Temperature Range (Class A): -30ºC to +70ºC
- Operating Temperature Range (Class B)*: -40°C to +85°C
POWER SUPPLY
- Power input and I/O via 4 way Molex mini-fit connector
- DC Power (8 - 40V DC)
- 1x dedicated ignition input on 4 way connector
- Minimum power input rating of 6W via 4 way mini-fit connector. Recommended power input 12V 1.5A.
- Vehicle compatible protection on DC Input Jack. (ISO7637 standard)
DIMENSIONS & WEIGHT
- Device dimensions (excluding external antenna):
143mm (L) x 107mm (W) x 34mm (D) / ~235g
MOUNTING OPTIONS
- Wall mount support in multiple orientations via embedded mounting holes
- DIN Rail mount support via plastic bracket included in box (Top hat section rail TH 35 IEC60715)
CERTIFICATIONS
Pending: FCC; IC; PTCRB; RoHS; WEEE
|